Product/Service

PREMO-PLUS

Source: IPS Group - Intelligent Pollution Solutions
premo
The PREMO-PLUS unit can be easily installed outside any engine as a by-pass system, not affecting the full flow system
The PREMO-PLUS unit can be easily installed outside any engine as a by-pass system, not affecting the full flow system. Oil enters the inlet port at the side under normal operating pressure. It is then channeled down through the spin-on filter where solid contaminants such as carbon, soot, dirt (silicon), wear metal particulate and any foreign solids are trapped. This filter contains a breakthrough in filter media technology. It is a synthetic media with a ISO BETA RATING of B3 = 200 (This Beta rating means that the filter traps 99.5% of all particles 3 microns or larger on each pass). Free of dirt and wear metal particles, the oil flows through a metering jet that allows 4 to 5 gallons per hour to travel into the patented evaporation chamber where it flows over an electrically heated surface in a thin film. The dirt free oil is heated to 195 degrees where the fuel dilution, water and liquid contaminants are evaporated and discharged through the upper vent tube. Completely clean oil returns to the engine by gravity. The continuous repetition of this cycle keeps your oil clean, increases the life of the engine and reduces your maintenance costs. Periodic laboratory oil analysis will virtually eliminate oil changes disposal costs.